Pioneer SC-LX85 Operating Instructions - Page 57

Using other functions 09 Using other functions About remote control operation Important ! The procedure for setting the receiver operation mode differs for the remote controls included with the SC-LX85 and SC-LX75. For the SC-LX85's remote control, set the remote control operation selector switch to RECEIVER. For the SC-LX75's remote control, press the button. When "set the remote control to the receiver operation mode" is indicated in these instructions, use the respective procedure described above. Setting the Audio options There are a number of additional sound settings you can make using the AUDIO PARAMETER menu. The defaults, if not stated, are listed in bold. Important ! Note that if a setting doesn't appear in the AUDIO PARAMETER menu, it is unavailable due to the current source, settings and status of the receiver. 1 Set the remote control to the receiver operation mode, then press AUDIO PARAMETER. 2 Use i/j to select the setting you want to adjust. Depending on the current status/mode of the receiver, certain options may not be able to be selected. Check the table below for notes on this. 3 Use k/l to set as necessary. See the table below for the options available for each setting. 4 Press RETURN to confirm and exit the menu. Audio parameter menu Setting MCACC (MCACC preset) EQ (Acoustic Calibration EQ) What it does Option(s) Selects your favorite MCACC preset memory when mul- c M1. MEMORY 1 to M6. tiple preset memories are saved. When an MCACC preset MEMORY 6 d memory has been renamed, the given name is displayed. Default: M1. MEMORY 1 ON Switches on/off the effects of EQ Pro. OFF Setting What it does Option(s) S-WAVE (Standing Wave) ON Switches on/off the effects of Standing Wave Control. OFF Phase C+ (Phase Control Plus) For discs created with standards other than Phase Control, the LFE channel is delayed upon recording in the first place. This function corrects for phase shifting on such discs. c 0 to 16 (ms) d Default: 6ms DELAY (Sound Delay) Some monitors have a slight delay when showing video, so the soundtrack will be slightly out of sync with the picture. By adding a bit of delay, you can adjust the sound to match the presentation of the video. c 0.0 to 10.0 (frames) d 1 second = 25 frames (PAL) Default: 0.0 TONE (Tone Control) Applies the treble and bass tone controls to a source, or BYPASS bypasses them completely. ON BASS Adjusts the amount of bass. c -6 to +6 (dB) d Default: 0 (dB) TREBLE Adjusts the amount of treble. c -6 to +6 (dB) d Default: 0 (dB) With the Auto Sound Retriever function, DSP processing OFF is used to compensate for the loss of audio data upon compression, improving the sound's sense of density and modulation. When ON is selected, the Sound Retriever effect is optimized based on the bitrate information of the con- S.RTRV (Auto Sound Retriever) tents input to the USB memory audio and HOME MEDIA GALLERY (digital audio input only) to achieve high sound quality. Also, when a player supporting the Auto Sound Retriever ON Link function is connected to the receiver by HDMI, by setting this to ON, the bitrate information of the com- pressed audio file being played on the player is acquired using the Control with HDMI function, and the sound is optimized based on this information (Auto Sound Retriever Link). DNR (Digital Noise Reduction) May improve the quality of sound in a noisy source (for OFF example, video tape with lots of background noise) when switched on. ON This only has an effect with 2-channel signal inputs. DIALOG E (Dialog Enhancement) Localizes dialog in the center channel to make it stand out from other background sounds in a TV or movie soundtrack. By moving from UP1 through UP2 and UP3 up to UP4, you can make the sound source seem to relocate upwards. c OFF/FLAT/UP1/UP2/UP3/ UP4 d Default: OFF En 57