Pioneer SX-A9MK2-K Owner's Manual - Page 26

07 Additional information Problem Can't operate the remote control. The display is dark or off. Remedy • Replace the battery (refer to page 7). • Operate within 7 m (23 ft.), 30° of the remote sensor on the front panel (refer to page 14). • Remove the obstacle or operate from another position. • Avoid exposing the remote sensor on the front panel to direct light. • Press DIMMER on the remote control repeatedly to return to the default. XM radio messages Message ANTENNA ANT ERR UPDATING NO SIGNAL LOADING OFF AIR CH- - - Cause The XM antenna is not connected. Action Check that the XM antenna cable is attached securely. A short-circuit occurring in the antenna or surrounding antenna cable. Make sure that there is nothing unusual with the antenna or antenna cable. Switch the power off then back on again. The radio is being updated with the latest encryption code. Wait until the encryption code has been updated. Channels 00 and 01 should function normally. The XM signal is too weak at the current n/a location. The receiver is acquiring audio or program Wait until the information has been received. information. The channel currently selected has stopped Select another channel. broadcasting. You have selected a channel that does not The receiver will automatically switch to exist, or that you have not subscribed to. channel 001 (or the last selected channel). There is no artist name/feature, song/ No action needed. program title, or channel category associated with the channel at this time. Specifications Amplifier section Power output specification is for when power supply is 120 V. • Continuous power output (both channels driven at 20 Hz to 20 kHz)** THD 0.2 %, 4 70 W + 70 W THD 0.2 %, 8 55 W + 55 W • FTC Continuous power output (both channels driven at 1 kHz) THD 1.0 %, 4 65 W + 65 W THD 1.0 %, 8 55 W + 55 W • Total harmonic distortion** 20 Hz to 20 kHz, 25 W, 8 0.05 %* * Measured with DIRECT button switched on. ** Measured by Audio Spectrum Analyzer 26 En