Pioneer SX-A9MK2-K Owner's Manual - Page 27
Signal-to-Noise Ratio IHF SHORTED
View all Pioneer SX-A9MK2-K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Additional information 07 English Audio section • Input (Sensitivity/Impedance) CD, TAPE, AUX 200 mV/22 kΩ PHONO (MM 2.8 mV/47 kΩ PHONO (MC 0.3 mV/100 Ω • Frequency response CD, TAPE, AUX 5 Hz to 100 kHz dB PHONO (MM 20 Hz to 20 kHz ±0.2 dB PHONO (MC 20 Hz to 20 kHz ±0.3 dB • PHONO (MM) overload level 1 kHz, THD 0.2 60 mV • PHONO (MC) overload level 1 kHz, THD 0.2 6 mV • Output (Level/Impedance) TAPE REC 200 mV/1 kΩ • Tone control Bass 10 dB (100 Hz) Treble 10 dB (10 kHz) • Signal-to-Noise Ratio (IHF SHORTED, A-Network) CD, TAPE, AUX (200 mV input 103 dB PHONO (MM, 2.8 mV input 80 dB PHONO (MC, 0.2 mV input 70 dB • FM Tuner Section Frequency Range 87.5 MHz to 108 MHz Usable Sensitivity Mono:13.2 dBf, IHF (1.3 µV/ 75 Ω) 50 dB Quieting Sensitivity Mono: 20.2 dB Stereo: 38.6 dBf Signal-to-Noise Ratio. . . .Mono: 73 dB (at 85 dBf) Stereo: 70 dB (at 85 dBf) Distortion Stereo: 0.5 % (1 kHz) Alternate Channel Selectivity . . . 60 dB (400 kHz) Stereo Separation 40 dB (1 kHz) Frequency Response 30 Hz to 15 kHz (±1 dB) Antenna Input 75 Ω unbalanced • AM Tuner Section Frequency Range 530 kHz to 1700 kHz Sensitivity (IHF, Loop antenna 350 µV/m Signal-to-Noise Ratio 50 dB Antenna Loop antenna Miscellaneous Power requirements. . . . . AC 120 V, 50 Hz/60 Hz Power consumption 200 W Power consumption (standby 0.8 W Dimensions 420 mm (W) x 113 mm (H) x 369 mm (D) (16 9/16 in. (W) x 47/16 in. (H) x 14 17/32 in. (D)) Weight (without package 11.5 kg (25 lb. 6 oz.) Accessories Remote control 1 AAA/IEC R03 dry cell batteries 2 AM loop antenna 1 FM wire antenna 1 Power cord 1 Warranty card 1 Operating instructions (This document) Note • Specifications and the design are subject to possible modifications without notice, due to improvements. Cleaning the unit • Use a polishing cloth or dry cloth to wipe off dust and dirt. • When the surface is dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and wrung out well, and then wipe again with a dry cloth. Do not use furniture wax or cleansers. • Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit, since these will corrode the surface. Published by Pioneer Corporation. Copyright © 2009 Pioneer Corporation. All rights reserved. 27 En