Pioneer VSX-815-S Owner's Manual - Page 71
Digital, Large, Small, Control In, Fl Dimmer
View all Pioneer VSX-815-S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
English Deutsch Français Italiano Nederlands Español Additional information 13 Problem Remedy No sound is output or a noise • Set the digital volume level of the player to full, or to the neutral is output when software with position. DTS is played back. • Make sure the player's settings are correct and/or the DTS signal out is on. Refer to the instruction manual supplied with the DVD player. • Set the input signal type to DIGITAL (see Choosing the input signal on page 38) When a search is performed • This is not a malfunction, but be sure to turn the volume down to by a DTS compatible CD prevent the output of loud noise from your speakers. player during playback, noise is output. Everything seems to be set up Check that the positive/negative speaker terminals on the receiver are correctly, but the playback matched with the corresponding terminals on the speakers (see sound is odd. Connecting the speakers on page 23). There seems to be a time lag • See Automatically setting up for surround sound (MCACC) on page 12 between the speakers and the to set up your system again using MCACC (this will automatically output of the subwoofer. compensate for a delay in the subwoofer output). After using the Auto MCACC • Low-frequency noise could have been caused by an air conditioner or Setup, the speaker size motor. Switch off all appliances in the room and rerun the Auto setting (LARGE or SMALL) is MCACC Setup. incorrect. Can't operate the remote control. • Replace the batteries (refer to page 7). • Operate within 23 ft. (7 m), 30° of the remote sensor on the front panel (refer to page 33). • Remove the obstacle or operate from another position. • Avoid exposing the remote sensor on the front panel to direct light. • Unplug anything connected to the CONTROL IN jack and use remote normally (see Operating other Pioneer components on page 26). The SR cable is connected, but the connected components can't be operated with the remote. • Reinsert the SR cable, making sure it's connected to the right jack (see Operating other Pioneer components on page 26). • Make sure an analog connection has been made between the units. • This feature only works with Pioneer products. The display is dark or off. • Press FL DIMMER on the remote control repeatedly to return to the default. 71 En