Pioneer VSX-D508 Owner's Manual - Page 23

3 Press A or v repeatedly to display the name of the component's manufacturer. VCR I -B li ir Inc -a ("VCR" is displayed on VSX-D508) 4 $ P 0 Eibb if PAN A30 NI -EH. PL.L311 ' ICIE3-ebn A list of all available preset codes is provided on page 56. 4 Point the remote toward the component to be controlled, enter the 3 digit setup code. When you enter the setup code, the remote emits a power ON/OFF signal. If the component turns ON or OFF, you have entered the proper code. If the component does not turn ON or OFF and there is more than one setup code, press c> to select another code in step 3 or try inputting another code (starting again from step 2). Some manufacturers use several sets of remote control signals and the first code may not correspond to your component. T 05H:I :OR -ob.. M PUSH LIDS- T0SHIIIR t PI.J51-4 909 -BL. Repeat steps 2 through 4 to assign preset codes for as many components as necessary. 5 Press COMMANDER SET UP to exit the preset mode. The remote control returns to the previous operation mode. memo • When operating a PIONEER'S DVD/LD player, set the manufacturer code to "000" in the preset mode. • All codes enrolled in the manufacturer code list can be set even if a code is not displayed. • RECEIVER cannot be preset. Clearing the Remote Control Settings Clears all presets and restores factory installed presets. • 0 Q.1) Press the COMMANDER SET UP and 0 at the same time for more 3 seconds. COMMANDER SET UP • All the multi-control buttons on the remote control blinks. After blinking three times, all the settings are canceled. 23