ProForm Endurance 720 E Instruction Manual - Page 12

12. Apply grease to a Pedal Arm Axle (64). 12 While a second person holds the front end of the Right Pedal Arm (58) inside the bracket on the Right Upper Body Leg (60), insert the Pedal Arm Axle (64) into both parts from the direction shown. Next, slide an M8 x 22mm Washer (77) onto an M8 x 13mm Screw (82), and tighten the Screw a few turns into the Pedal Arm Axle (64). Then, tighten the Pedal Arm Axle (64) and the M8 x 13mm Screw (82) at the same time. Repeat this step on the other side of the elliptical. 46 60 82 77 Grease 64 58 13. Orient the Rear Upright Cover (81) as shown. 13 Attach the Rear Upright Cover (81) to the Upright (4) with four M4 x 16mm Screws (101); start all the Screws, and then tighten them. Next, orient the Front Upright Cover (117) as shown. Attach the Front Upright Cover (117) around the Upright (4) by pressing it onto the Rear Upright Cover (81). 81 4 117 101 12