Pyle PKBRKTL200 Instruction Manual - Page 13
Cleaning And Maintenance
View all Pyle PKBRKTL200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
11. Automatic memory saving function When the program is nished and the machine is shut down after running every time, the running program and settings will be saved automatically. When the machine is started up again next time, the running program and settings of last time will be retrieved from the memory automatically and run again. CLEANING AND MAINTENANCE Cleaning your Beer Brew Automatic after use: After use you should empty the brew kettle of any remaining trub. Use warm water and a soft kitchen brush only to gently clean the equipment. You can also use a PBW cleaner to soften any burnt material in the bottom of the brew kettle. Add about 5-10 litres of water, press "On" on the brew controller display, switch the brew program selector to "II", then press "Run". Connect the whirlpool arm. When the water is boiling, open the riser pipe valve and switch on the pump and let it run for about 5 minutes in order to clean the equipment pipes and pump, then switch the equipment o . Empty the brew kettle, dry of the equipment and store until your next brewing session. Note: Do not use a hard brush as it can create scratch marks on the equipment surfaces. Do not submerge the base of the brew kettle in water. Cleaning the pump: Sometimes some material can get into the pump, preventing the impeller inside the pump front casing from running. In case of clogging you may need to take the pump out for manual cleaning. Ensure that the Home Beer Brewing Machine is empty and cooled down to approximately room temperature. Disconnect the power cord from the wall outlet and place the brew kettle upside down. #4 #5 #3 #1 #2 www.NutrichefKitchen.com 13