Pyle PPDM2 PPDM2 Manual 1 - Page 20
Number, Steps
View all Pyle PPDM2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
It is important that you also perfonn the calibration for walking, as described in the following section: • You can choose bet\veen YES and NO with the C button. Choose YES and confinn with the A button. , Display SET CALI DISTANCE appears, choose with the C button (0.1 to 1.0 km possible), confirm wi th the A button. • Display PRESS SET TO START appears, start with A button. Now walk the chosen distance (the display PRESS TO END appears) and press the A button afterwards. • Display CALI OKI and SAVED appears. The calibration was correct and was saved. • Finally press the 0 button, the watch changes to the initial position (display of current speed and lower and upper limits for the speed). Number of Steps Press the C button in the pedometer mode until STEP is displayed . The num ber of steps is shOwn in the lower segment of the display, in the middle the current speed. _ " "'0,,- ~ 3'~m/h Number of steps -'..,...-~ 81 • Keep the A button pressed - the display RESET appearsreset the number of steps to zero. Calibration not Successful. In case the calibration was not successful, the display CALI FAILED appears. After a few seconds the display CALI FOR RUNNIN G or WALKING appears again and you can start a new calibration. Stop Calibration Press the 0 button during calibration in case you want to stop the calibration. The display CALI CANCEL appears. The watch automatically changes to the initial position (display of current speed and lower and upper limits for the speed). You can now start a new calibration.