RCA HSDB2A Quick Start Guide - Page 14

Doorbell Camera

Get RCA HSDB2A PDF manuals and user guides View all RCA HSDB2A manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

TOUR OF THE DOORBELL CAMERA FRONT BACK Lens captures video in front of the doorbell. Micro SD card slot holds the micro SD card that comes with your doorbell camera. IR sensor detects changes in ambient light and adjusts video settings accordingly. RESET button restores the doorbell camera to factory settings (hold for 15 seconds). Call button triggers the doorbell. Screw terminals connect to the doorbell power source from your home. Removing/Replacing the SD Card Your doorbell camera comes with an SD card pre-installed, for recording alerts. To remove or replace this card, you'll first need to remove the doorbell camera's faceplate by unlocking its set screws and pulling it off. Press the installed SD card to unlock it and pull it out. Place the new SD card in and lock it into place. Then place the SD card cover back on and put the doorbell camera's faceplate over the doorbell camera. Finally, insert the set screw and screw it back in place. 14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
14
TOUR OF THE
DOORBELL CAMERA
FRONT
BACK
Lens
captures video in front of the doorbell.
Micro SD card slot
holds the micro SD card
that comes with your doorbell camera.
IR sensor
detects changes in ambient light
and adjusts video settings accordingly.
RESET button
restores the doorbell camera
to factory settings (hold for 15 seconds).
Call button
triggers the doorbell.
Screw terminals
connect to the
doorbell power
source from your
home.
Your doorbell camera comes with an SD card pre-installed, for recording alerts.
To remove or replace this card, you’ll first need to remove the doorbell camera’s
faceplate by unlocking its set screws and pulling it off. Press the installed SD card
to unlock it and pull it out. Place the new SD card in and lock it into place. Then
place the SD card cover back on and put the doorbell camera’s faceplate over the
doorbell camera. Finally, insert the set screw and screw it back in place.
Removing/Replacing the SD Card