RCA HSDB2A Quick Start Guide - Page 8
Turn on power to your doorbell's circuit
View all RCA HSDB2A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
CONNECT & MOUNT THE VIDEO DOORBELL (continued) OPTION B: If your home's doorbell power wires are NOT long enough. Terminals Loosen Use the screwdriver provided in this package to loosen the terminal screws on the back of the video doorbell. 10 Turn on power to your doorbell's circuit Turn the circuit that powers your doorbell back on. Doorbell camera back Wire nut Home doorbell wire Twist Wire lead Place the terminal of each provided wire lead completely under each terminal screw. Then retighten both terminal screws. RESISTOR INSTRUCTIONS (IF YOU DON'T HAVE A CHIME BOX) To install the resistor provided: Remove the sheaths covering the ends of the resistor. Put one end of the resistor together with one of the wire leads connected to the video doorbell. Use one of the provided wire nuts to twist these ends together. Connect the other end of the resistor to your home doorbell wire following the instructions below. Put the ends of one wire lead and one home doorbell wire together and insert them into a wire nut. Then twist the wire nut until you feel tension. Repeat with the other wire lead, home doorbell wire, and wire nut. 11 Confirm the video doorbell has power The indicator around the doorbell's call button flashes when it has power (first red, then blue). If the indicator is flashing: Go to the next step. If the indicator is NOT flashing: First, check the connections on the back of the video doorbell. Then, press and hold the reset button on the front of the video doorbell for 4 seconds, until the doorbell says "reset successful." 8