RCA HSDB2A Quick Start Guide - Page 3

ncil or marker CONNECT & MOUNT THE POWER KIT IMPORTANT: If your doorbell does not have a chime box, you will need to install the resistor provided to regulate the power to the doorbell camera. You can skip this section and follow the instructions in the "If You Don't Have A Chime Box" section on page 7. 1 Turn off power to your doorbell's circuit 3 Connect the power kit connection wires to the power kit Insert the joined connector into the slot on the side of the power kit. Find the breaker that controls the circuit for your doorbell. Turn it off before you continue installation. 4 Remove the existing wires from the chime terminals Loosen the terminal screws for the doorbell you want to replace. REAR TRANS FRONT REAR TRANS FRONT Remove the leads from those terminals. IMPORTANT: Keep track of which lead goes to which terminal! 2 Remove the cover from your doorbell's chime box Find your doorbell's chime. Remove its cover. 5 Connect the power kit connection wires to the chime terminals. REAR TRANS FRONT Remove the sheaths covering the ends of the solid-wire power kit leads. Bend the ends of each lead over the terminals where the old leads were. Then tighten the terminal screws to hold the leads in place. 3