RCA RCU811 User Guide - Page 16

RCU811US_IB_REVB 9/26/03 11:54 AM Page 16 Glossary of Terms AUDIO FEATURES AM•FM KEY The AM•FM key allows you to select the AM or FM band on your AUDIO system. CENTER, FRONT, REAR & TEST KEYS You can adjust the levels of the center, front and rear speakers by using the LEVEL+/UP ARROW or LEVEL-/DOWN ARROW keys. The TEST key is used when you make speaker balance adjustments to maximize the performance of your AUDIO system. CD, TAPE, TUNER, TV, VIDEO KEYS Use the CD, TAPE, TUNER, TV and VIDEO keys to select the component you want to control. DSP MODE KEY When the Digital Signal Processing (DSP) Mode is enabled, pressing this key allows you to cycle through the various DSP Modes. DSP ON.OFF KEY Pressing this key allows you to turn the DSP mode on or off. LEVEL+/UP ARROW AND LEVEL-/ DOWN ARROW KEYS The LEVEL+/UP and LEVEL-/DOWN ARROW keys are used to make adjustments on delay time, center speaker output level, rear speaker output level, front speaker level or subwoofer level. BACKLIGHT KEY The BACKLIGHT key turns the LCD Backlighting on or off. COMPONENT KEYS The component keys change the component currently being controlled by the remote (e.g., TV, VCR, SAT•CBL, DVD, AUDIO, CD, AUX1, AUX2). The AUDIO key allows you to control your TUNER, TAPE and AMP. ENTER KEY The ENTER key is used to complete channel selections for some brands of TVs. Sometimes it is also used to complete the highlighted sections when navigating through menu screens. This key is also used during Setup Mode to activate certain functions. GO BACK KEY The GO BACK key allows you to go to the previous channel you selected. It operates the same as the Last Channel, Previous Channel or Recall keys on your existing remote. GUIDE KEY If your component is equipped with this feature, the GUIDE key brings up the on-screen program listing. LEARN The LEARN feature is used to supplement the preprogrammed Code Lists. The standard Code Lists provide most of the functions needed, but you can add a small number of additional functions of your choice. LIQUID CRYSTAL DISPLAY The Liquid Crystal Display (LCD) provides a visual interface between the user and the remote. The LCD status display remains blank when the remote is not in use. Pressing any key displays the current component mode and the time. The LCD status display turns off after approximately 15 seconds from the last keypress, except when an Event Timer is set. In this case, the LCD remains on until the event has occurred. L1, L2, L3 KEYS The L1, L2, and L3 are generic keys that can be used to store learned commands. 16