RCA RCU811 User Guide - Page 8

RCU811US_IB_REVB 9/26/03 11:54 AM Page 8 Code Identification Chart Enter your code here for easy reference. TV CODE AUX 1 device:______ AUDIO Tuner ❒ AMP ❒ Tape ❒ VCR CODE AUX 2 device:______ CD CODE SAT•CBL CODE DVD CODE Learning Learning Tips Before transferring commands from your original remote to the RCU811, check out these useful tips on Learning. 1. Make sure you are using fresh batteries in both the RCU811 and your original remote(s). 2. It is recommended that you clear all Learned commands under all component modes before attempting any Learning. (See section on Clear all Stored Learned Commands Under a Component Mode.) 3. Point the top of the original remote at the base of the RCU811 so the IR LED on the original remote is in line with the RCU811 Learn sensor, located at the bottom of the remote. 4. The distance between the two remotes should be approximately 2-3 inches apart. 5. To ensure that your units are compatible and to increase your familiarity with the Learning process, you may wish to experiment by learning two or three keys initially. Then, carry out a Clear all Stored Learned Commands Under a Component Mode operation before learning all the desired functions from your original remote. 6. Incandescent or low-energy light can cause interference with the IR transmissions. When using the Learning function, keep the remotes at least three feet away from such light sources. 7. When learning a key, do not release the key on your original remote until the Success Screen is displayed on the RCU811 status display, which takes approximately 2-3 seconds. Until this occurs, the LCD will display the Learn Screen. 8. Any key on your RCU811 can be programmed with Learned commands, with the exception of the MACRO (M), SETUP (S), BACKLIGHT, INPUT or any component key. In addition, the L1, L2 and L3 keys are generic keys to be programmed as you wish. 9. If there is a problem during the Learning process, the Learn Error Screen appears in the display. The unit still remains in Learning Mode. 10. All Learned keys are saved automatically. 11. When the memory is full, the display shows the Full Screen. It is not possible to learn any additional keys without first clearing Learned commands under a component mode. 8