Ricoh Priport DX 4640PD Network Guide - Page 34
Printing with a Mac OS, Changing to EtherTalk
View all Ricoh Priport DX 4640PD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Using the Printer Function Printing with a Mac OS This section describes how to configure a Mac OS computer to use EtherTalk. Actual procedures may vary depending on the version of the Mac OS. The following procedures describe how to configure Mac OS 9.1 and Mac OS X v10.1. If you are using other version than Mac OS 9.1 and Mac OS X v10.1, see the manual that comes with Mac OS for details. 5 Note ❒ Mac OS 8.6 and later versions are supported (except for Mac OS X v10.0.x). ❒ To print from a Mac OS, PostScript3 board is required. Changing to EtherTalk Follow the procedure below to configure a Mac OS computer to use EtherTalk. Reference For details about installing the software required for EtherTalk, see the Mac OS manuals. Mac OS A Open [Control Panel], and then double-click the AppleTalk icon. B On the [Connect via] pop-up menu, click [Ethernet]. C If you change zones, select a name on the [Current zone] pop-up menu. D Close the [AppleTalk] control panel. E Click [Save]. F Restart the Mac OS. 28