Ryobi RTS10G User Manual - Page 13

ASSEMBLY INSTALLING THE REAR BRACKET/CARRYING HANDLE See Figure 9. CAUTION: A rear bracket is included with this miter saw to prevent tipping if the saw arm is released suddenly. Do not use this saw before installing the rear bracket/carrying handle and securely mounting the saw to a work surface or stand and may result in personal injury.  Remove the screws from the rear bracket/carrying handle and set aside.  Slide the bracket in the openings on the saw base, aligning the holes underneath the base with the holes in the bracket.  Insert the screws into the holes and tighten securely. DUST BAG See Figure 10. A dust bag is provided for use on the miter saw. It fits over the exhaust port on the upper blade guard. Squeeze the two metal clips to open the mouth of the bag and slide it on the exhaust port. Release the clips. The metal ring in the bag should lock in between the grooves on the exhaust port. To remove the dust bag for emptying, simply reverse the above procedure. WORK CLAMP See Figure 11. The work clamp provides greater control by clamping the workpiece to the fence. It also prevents the workpiece from creeping toward the saw blade. This is very helpful when cutting compound miters. Depending on the cutting operation and the size of the workpiece, it may be necessary to use a C-clamp instead of the work clamp to secure the workpiece to the miter table prior to making the cut. WARNING: In some operations, the work clamp assembly may interfere with the operation of the blade guard assembly. Always make sure there is no interference with the blade guard prior to beginning any cutting operation to reduce the risk of serious personal injury. To install the work clamp:  Place the shaft of the work clamp in either hole on the miter table base.  Rotate the knob on the work clamp clockwise to move it in or counterclockwise to move it out as needed. REAR BRACKET/ CARRYING HANDLE DUST BAG EXHAUST PORT BASE 13 SCREWS Fig. 9 22.5 31.6 31.6 22.5 Fig. 10 WORK CLAMP Fig. 11