Samsung DVD R130 User Manual (ENGLISH) - Page 125

Step 5 : Connecting the Power Cord After all connections are complete, plug the power cord in the wall outlet. "Auto" appears in the panel display. This means that the current time is being set automatically (Auto Program) through the antenna under connection and also the channel is being set. The setup may take a few minutes. When the DVD Recorder operates normally, the current time is automatically set and displayed in the front panel display. NOTE s After the current time is set automatically, the recorder will perform Auto Channel Memory for about 3 minutes. If power is on before finishing the Auto Channel Memory process, Auto Channel Memory will stop. In this case, do Auto Channel Memory from MENU(see page 31). Step 6 : Preparing the Remote Control Install Batteries in the Remote Control • Open the battery cover on the back of the remote. • Insert two AAA batteries. Make sure that the polarities (+ and -) are aligned correctly. • Replace the battery cover. If the remote control does not operate properly: • Check the polarity + - of the batteries (Dry-Cell) • Check if the batteries are drained. • Check if remote sensor is blocked by obstacles. • Check if there is any fluorescent lighting nearby. Dispose of batteries according to local environmental regulations. Do not put them in the household trash. English - 27 Connecting & Setting Up