Samsung SNT-1010 User Manual - Page 10

Installing and Connecting Connecting SNT-1010 (Continued) To Connect the Power 3 Power Cable 2 AC Adapter 1 SNT-1010 1 Connect the AC adapter to the Power port of the SNT-1010. 2 Connect the power cable to the AC adapter. 3 Plug the power plug into the wall outlet. If the power is connected,the [POWER]LED is turned on. Use AC adapter authorized by the company only. (DC 8.4V/1A) Notice 18 Network Connection & Setup You can set up the SNT-1010 network settings according to your network configurations. SNT-1010 network connection and setup processes are given as follows. Connect SNT-1010 to an IP sharer with a xDSL/Cable modem Page 20 Connect SNT-1010 to an IP sharer with local area networking Page 25 Connect SNT-1010 directly to a DHCP-based xDSL/Cable modem Page 30 Connect SNT--1010 directly to local area networking Page 31 SNT-1010 compliant IP sharers are as listed below. Note - LINKSYS WRT54G - D-LINK DI-624 - NETGEAR WGT624 Do not use other IP sharers than SNT-1010 authorized ones.Otherwise, it can cause a network error. Depending on the performance of the PC (Viewer installed)or the network,the video transmission can be delayed or even disconnected. For soft video transmission,you can set the bandwidth in under the SNT-1010 setup menu. LINKSYS WRT54G IP sharer is taken example for the description of the IP settings in this manual. For more information on the third party's IP sharer, refer to the product's documentation. The IP and MAC addresses used in this manual are for illustrative purposes only.Therefore,you must refer to Notice the network settings of your PC and do not enter the addresses presented in this manual. 19 Chapter 2 Installing and Connecting Connecting the SNT-1010/Network Connection &Setup