Samsung SNT-1010 User Manual - Page 12

Network Connection & Setup To Connect SNT-1010 to an IP sharer with the xDSL/Cable modem (Continued) B. If the IP sharer is connected to an xDSL modem using DHCP 4 22 1 Launch an Internet browser on the local PC connected to the IP Sharer. 2 Enter the IP Sharer's address in the address bar of the browser. ex) http://192.168.1.1 ,http://192.168.0.1 or http://192.168.xxx.1 For the address of the IP sharer, refer to the product's documentation. 3 When the IP Sharer is connected, the login window appears and prompts you to enter the password. For the login IP and the password, refer to the IP sharer's documentation. 4 When done, you will see the setup window of the IP sharer. In the setup menu, select "Automatic Configuration-DHCP " for Internet Connection Type. For the menu location of Internet Connection Type and DHCP, refer to the IP sharer's documentation. 5 Some Internet service providers may require additional information such as user ID, password or host name for the connection using DHCP. For more information, contact your Internet service provider. 6 When done, click the or button to save the settings. [STEP 3 ] To check if the IP sharer is connected to the xDSL /Cable modem properly Select from the Settings menu of the IP Sharer If it is properly connected, , and provided by your ISP are displayed. Please remember these values because they are required so that an external remote computer of the IP sharer connects to SNT-1010. However, note that certain ISPs change the settings of , and on a regular basis If the IP sharer is not properly connected, press the button to try to reconnect or check if the settings of the IP sharer are correct. [STEP 4 ] To connect SNT-1010 to the IP sharer A. If using Dynamic IP mode of SNT-1010 1. Position the IP selection switch to D (Dynamic IP). 2. SNT-1010 is connected to the IP sharer using the Direct LAN Cable (UTP cable). SNT-1010 does not come with the Direct LAN cable. You have to purchase it separately. 3. Connect SNT-1010 to the power source. 4. When SNT-1010 starts, it automatically obtains an IP address from the IP sharer. 5. You can check the dynamic IP address from the IP sharer by using the IP installer on your PC. For how to use the IP installer, refer to "Dynamic IP Setting: Check Dynamic IP" on page 38. B. If using Static IP mode of SNT-1010 1. Position the IP selection switch to S (Static IP). 2. SNT-1010 is connected to the IP sharer using the Direct LAN Cable (UTP cable). SNT-1010 does not come with the Direct LAN cable. You have to purchase it separately. 3. Connect SNT-1010 to the power source. 4. Use the IP installer on your local PC to configure the , , and settings. For how to use the IP installer, refer to "Static IP Setting" on page 33. 23 Chapter 3 Network Connection &Setup To Connect SNT-1010 to an IP sharer with the xDSL/Cable modem