Samsung WF455ARGSGR/A2 User Manual Ver.1.0 (English, French, Spanish) - Page 20
Important Note To Installer
View all Samsung WF455ARGSGR/A2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
installing your washer IMPORTANT NOTE TO INSTALLER Please read the following instructions carefully before installing your Washer. These instructions should be retained for future reference. We recommend you hire a professional for installation of this washer. Installation flow chart Selecting a location Removing the shipping bolts (*Drum only) Connecting the water and the drain Please check again before steps. Adjusting the levelling feet Powering your washing machine [Running a test cycle] Run a test cycle (Rinse+Spin) with small amount of laundary (about 4~5 Towels) Does your washer have excess vibration Yes or noise? Running a Calibration mode (Refer to the following No description) Finish the installation STEP 1 Selecting a Location Before you install your washer, make sure the location: • Has a hard, level surface without carpeting or flooring that may obstruct ventilation. • Has no dust, oil and detergent etc. • Is away from direct sunlight • Has adequate ventilation • Will not freeze (below 32°F or 0°C) • Is away from heat sources such as oil or gas • Has enough slack for the power cord. • Doesn't have any carpeting that will obstruct ventilation openings. STEP 2 Removing the Shipping Bolts Before using your Washer, you must remove the four shipping bolts from the back of the unit. 1. Loosen all the bolts with the supplied wrench. 2. Slide the bolt and spacer up and remove the bolt with the spacer through the hole in the rear wall of your washer. Repeat for each bolt. 3. Fill the holes with the supplied Bolt Hole Covers (See page 16). 4. Keep the shipping bolts and spacers for future use. 20_ installing your washer WF455AG-03159A-04_EN.indd Sec3:20 2012-11-28 2:07:28