Samsung WF455ARGSGR/A2 User Manual Ver.1.0 (English, French, Spanish) - Page 21

01 installing your washer STEP 3 Installing your Washer 1. Place the drain hose in the drain facility. Be sure an airtight connection is NOT made between the drain hose and the standpipe. The standpipe must be at least 18 in or 46 cm high. Caution must always be exercised to avoid collapsing or damaging the drain hose. For best results, the drain hose should not be restricted in any way - by elbows, couplings, or excessive lengths. For situations where the drain hose cannot be conveniently elevated to at least 18 in or 46 cm, the drain hose must 96" Max be supported. 18" Min Laundry tub Stand pipe Hose retainer Tie strap 96" Max 18" Min 2. Check the inlet hose to ensure a washer is inside each fill hose. Cold Thread the inlet hoses to the HOT and COLD faucet connections. On the other end of the hose, check for one rubber washer per hose and install each fill hose to the water valve. Make sure the hose with the Hot printed line is attached to the HOT faucet. Tighten by hand until snug, then two-thirds of a turn with pliers. 3. Connect the other end of the Hot and Cold water supply hose to the inlet water valve at the rear of the washing machine.Tighten by hand until snug, then two-thirds of a turn with pliers. Cold printed Hot Rubber Washer Hot printed For correct water use, connect both HOT and COLD water valves. If either or both are not connected, an "nF" (no fill) error can occur. 4. Turn on the "HOT" and "COLD "water supply and check all connections at the water valve and the faucet for leaks. WF455AG-03159A-04_EN.indd Sec3:21 installing your washer _21 2012-11-28 2:07:28