Samsung WF455ARGSGR/A2 User Manual Ver.1.0 (English, French, Spanish) - Page 32
Connecting to the network using the WPS setting
View all Samsung WF455ARGSGR/A2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
washing a load of laundry Connecting to the network using the WPS setting • Samsung washers use PBC as the WPS type. Check if the current wired/wireless router supports Wi-Fi Protected Setup™(WPS). • Check if the wired/wireless share has a WPS button. 1. Press and hold both the Temp. and Start/Pause buttons for 5 seconds. 2. Turn the Cycle Selector until "UP" is displayed on the display panel and press the Start/Pause button. If the connection is not established within 5 minutes, "FUP" is displayed on the display panel. 3. Press and hold the WPS button of the wired/wireless router that will be connected with the washer for 120 seconds or less to run the WPS function of the wired/ wireless router. If the WPS function runs, the wired/wireless router automatically fetches the necessary information from the washer and the washer is automatically connected to the Internet through the wired/wireless router. • How to use the WPS function of the wired/wireless router may differ depending on the manufacturer. Refer to the user manual of the corresponding wired/wireless router. • Even after the WPS setup is complete, it may take some time until the actual connection is established to allocate an IP address through DHCP (up to 5 minutes). • Note that if you use a wired/wireless router that is not WPS-certified, the washer CAUTION may not be connected through Wi-Fi or a device that was connected to the wired/ wireless router may be disconnected. • Please note that for some wired/wireless routers, if you press and hold the WPS button for some time, the settings of the router may be reset. 4. If the washer and the wired/wireless router are properly connected, the indicator blinks on the display panel for 30 seconds. 5. Press the Smart Control button to finish the Smart Control connection setup. When the setup is completed normally, the indicator blinks on the display panel with a beeping sound. If you press the Smart Control button when the washer and the wired/wireless router are not properly connected, the invalid button sound is heard and the Smart Control connection setup is not completed. 32_ washing a load of laundry WF455AG-03159A-04_EN.indd Sec5:32 2012-11-28 2:07:30