Sanyo HD2000 Instruction Manual, PLV-HD2000 - Page 14
Audio Output Jacks, Reset Button, R/c Jack, Serial, Out Terminal, In Terminal, Usb Port, Series B
UPC - 086483060502
View all Sanyo HD2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
INPUT 1 INPUT 2 CONNECTING PROJECTOR SERIAL PORT IN TERMINAL If you control a projector by computer, you must connect a cable (not supplied) from your computer to this terminal. USB PORT (Series B) This port is used to service this projector. Connect USB port of computer to this port. SERIAL PORT OUT TERMINAL This terminal outputs signal from SERIAL PORT IN. More than two projectors can be controlled with one computer by connecting SERIAL PORT IN. of another projector to this terminal. SERIAL PORT IN SERIAL PORT OUT R/C JACK USB AUDIO OUT R L RESET (MONO) IN LINK A OUT IN LINK B OUT R/Pr G/Y B/Pb H/HV V AUDIO R L CONTROL PORT (MONO) DVI AUDIO CONTROL PORT R L (MONO) R/C JACK When using Wired / Wireless Remote Control Unit as Wired Remote Control, Connect Wired Remote Control Unit to this jack with Remote Control Cable (not supplied). (Refer to page 19.) RESET BUTTON This projector uses a micro processor to control unit. Occasionally, micro processor may malfunction and need to be reset. This can be done by pressing RESET button with a pen, which will shut down and restart unit. Do not use RESET function excessively. AUDIO OUTPUT JACKS Connect an external audio amplifier to these jacks. (Refer to P15, 16.) INPUT 3 INPUT 4 14