Sanyo HD2000 Instruction Manual, PLV-HD2000 - Page 20

BEFORE OPERATION REMOTE CONTROL CODE CHANGE AND OPERATING RANGE Code Change This projector has eight different remote control codes (Code 1-Code 8); the factory-set, initial code (Code 1) and the other seven codes (Code 2 to Code 8). This switching function prevents remote control interference when operating several projectors or video equipment at the same time. (Change the remote control code for the projector first before changing that for the remote control. See "Remote control" on page 40.) 1 While pressing the MENU button, press the IMAGE button number of times corresponding to each remote control code number. Each time you press the IMAGE button, the code is changed sequentially. (See the list below.) 2 To initialize the remote control code for the remote control, slide the RESET switch to the RESET, and then to the ON. The initial code is Code 1. Remote Control Code Code 1 Code 2 Code 3 Code 4 Code 5 Code 6 Code 7 Code 8 Number of Times of Pressing IMAGE Button 1 2 3 4 5 6 7 8 ZOOM FOCUS ON-OFF SELECT RESET MENU button IMAGE button Operating Range Point Remote Control Unit toward projector (Receiver Window) whenever pressing any button. Maximum operating range for Remote Control Unit is about 16.4' (5m) and 60° in front and rear of a projector. 60° 16.4' (5 m) 16.4' (5 m) 60° REMOTE CONTROL BATTERIES INSTALLATION 1 Remove battery compartment lid. Press lid downward and slide it. 2 Slide batteries into compartment. 3 Replace compartment lid. Two AA size batteries For correct polarity (+ and -), be sure battery terminals are in contact with pins in compartment. 20 To insure safe operation, please observe following precautions : G Use (2) AA or R06 type alkaline batteries. G Replace two batteries at same time. G Do not use a new battery with an used battery. G Avoid contact with water or liquid. G Do not expose Remote Control Unit to moisture, or heat. G Do not drop Remote Control Unit. G If a battery has leaked on Remote Control Unit, carefully wipe case clean and install new batteries. G Danger of explosion if battery is incorrectly replaced. G Dispose of used batteries according to the batteries manufacturers instructions and local rules.