Sanyo PLC-HF15000L Owner's Manual - Page 63
Power management, Direct on, RC sensor, signal
View all Sanyo PLC-HF15000L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Settings RC sensor Select a location of the infrared remote receiver of the remote control. See "Remote Control Receivers and Operating Range" on page 15 for details. All Activates all of the receivers Front & Top....... Activates both the front and top receivers Top & Back....... Activates both the top and back receivers Front & Back.... Activates both the front and back receivers Front Activates only the front receiver. Top Activates only the top receiver Back Activates only the back receiver. ✔Note • When placing the projector in the horizontal position, as fluorescent light may negatively affect the remote control signals, it is recommended to select either "Back" or "Front" to prevent the receiver on top of the projector from picking up the signals from the remote control. Power management For reducing power consumption as well as maintaining No signal the lamp life, the Power management function turns off the projection lamp when the projector is not operated for a 4 : 50 certain period. Select one of the following options: Timer left before Lamp is off. Ready When the lamp has been fully cooled down, the POWER indicator changes to green blinking. In this condition, the projection lamp will be turned on if the input signal is reconnected or any button on the side control or remote control is pressed. Shut down.......... When the lamp has been fully cooled down, the power will be turned off. Off Power management function is off. Timer If the input signal is interrupted and no button is pressed for more than 30 seconds, the timer display with No signal appears. It starts the countdown until the lamp is turned off. Use the Point ed buttons to set the Timer(1~30Min). ✔Note • Factory default is Ready: 5 Min. • When the shutter is closed while the Power management function is working, the Power management function is released. Direct on When this function is set to On, the projector will be automatically turned on just by connecting the AC power cord to the wall outlet. ✔Note • Be sure to turn off the projector properly (see "Turning Off the Projector" on page 25). If the projector is turned off in the incorrect sequence, the "Direct on" function does not work properly. 63