Sharp AN-ACS1U ANACS1U Operation Manual - Page 20

General control Subwoofer control The subwoofer level can be adjusted. Press SUBWOOFER LEVEL. • The current subwoofer level setting is shown. When you press the button again while the level is shown (within 3 seconds), you can change the subwoofer level. To increase the level, press SUBWOOFER LEVEL +. To decrease the level, press SUBWOOFER LEVEL -. Shown for about 3 seconds • If the subwoofer level is too high, resulting in distortion, you should lower the level. To change the tonal quality of the sound You can choose among three sound modes for the tonal quality. Press TONE. • The current sound mode is shown. When you press the button again while the mode is shown (within 3 seconds), you can change the sound mode. • Each push of the button cycles through the following settings. NORMAL HEAVY LIGHT Shown for about 3 seconds Volume control Main unit operation: Press VOLUME + to increase the volume and VOLUME - for decreasing. Remote control operation: Press VOLUME + to increase the volume and VOLUME - for decreasing. Muting The sound is muted temporarily when pressing MUTE on the remote control. Press again to restore the sound. NOTE • When you press another button, muting is canceled. However, it is not canceled if INPUT or MENU is pressed. • When the unit is tuned off and back on again, muting is canceled. To dim the display 1 Press MENU. 2 Use c/d to select "DIM". 3 Use a to select "ON" and press ENTER. • The display will be turned off. • If DVS or Audistry has been selected, the respective sound mode icon will be shown also while the display is off. • If a button is pressed while the display is dimmed, the current setting will be shown for 3 seconds, and then the display goes off again. To cancel the setting Use b to select "OFF" and then press ENTER. 18