Sharp AR-M350 AR-M280 AR-M350 AR-M450 Operation Manual (for multifunction - Page 109
System settings network settings, IP address setting, Enable TCP/IP, Enable NetWare, Enable
View all Sharp AR-M350 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
KEY OPERATOR PROGRAMS System settings (network settings) These programs are set when this product is used as a network printer. In "Network Settings", the following programs can be set. After each program is set, exit the key operator program, turn off the main switch, and then turn on the main switch again after a while. The program that has been set will be effective at this time. G IP address setting G Enable TCP/IP G Enable NetWare G Enable EtherTalk G Enable NetBEUI G Reset the NIC NOTE For setting and modification of "Network settings", be sure to consult with the network administrator. *1 Reset the NIC This program is used to reset all setting items of NIC (Network Interface Card, namely Print Server Card) of this product to the factory default settings. NOTE For programs marked with *1, a confirmation message for execution will appear at the end of the programs. When the operation panel on the main unit is used, execution of the program can be canceled by pressing the [BACK/C] key. When the operation panel with touch panel is used, execution of the program can be canceled by touching the [CANCEL] or [NO] key. IP address setting When using this product in a network that uses the TCP/IP protocol, use this program to set the IP address (IP address, IP subnet mask, and IP gateway) of this product. When using this product in a network that uses the TCP/IP protocol, set also the program "Enable TCP/IP" below. Enable TCP/IP 6 When using this product in a network that uses the TCP/IP protocol, set this program. Also set the IP address using the program "IP address setting" above. Enable NetWare When using this product in a network that uses the NetWare protocol, set this program. Enable EtherTalk When using this product in a network that uses the EtherTalk protocol, set this program. Enable NetBEUI When using this product in a network that uses the NetBEUI protocol, set this program. 6-13