Sharp AR-M350 AR-M280 AR-M350 AR-M450 Operation Manual (for multifunction - Page 61
Misfeed in the multi purpose drawer, Misfeed in the stand/3 x 500 sheet paper, drawer, Misfeed
View all Sharp AR-M350 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
MISFEED REMOVAL s Misfeed in the multi purpose drawer 1 If the machine is equipped with a stand/ paper drawer, open the side cover of the stand/paper drawer. Hold the knob and gently open the cover. If the machine is not equipped with a stand/ paper drawer, proceed to step 4. 2Remove the misfed paper. Be careful not to tear the misfed paper during removal. s Misfeed in the stand/MPD & 2000 sheet paper drawer For misfeed removal in the upper tray, follow the procedure of "Misfeed in the multi purpose drawer" shown to the left to remove the misfed paper. For misfeed removal in the lower large capacity tray, follow the procedure below. 1 Follow steps 1 to 3 of "Misfeed in the multi purpose drawer" shown to the left. 2 If misfed paper is not found in step 1, refer to "Misfeed in paper tray 1" (steps 1 and 2 on page xxxx) to remove the misfed paper. 3 If misfed paper is not found in steps 1 and 2, pull out the large capacity tray (lower tray) and remove the misfed paper. NOTE Since paper may be misfed in the inner part, check carefully and remove it. 4 q If paper is misfed on the right paper feed table: 3 Close the side cover of the stand/paper drawer. 4 If misfed paper is not found in step 2, refer to "Misfeed in paper tray 1" (steps 1 to 5 on page xxxx) to remove the misfed paper. s Misfeed in the stand/3 x 500 sheet paper drawer For misfeed removal in the upper tray and middle and lower trays, follow step 1 to 4 of the description of "Misfeed in the multi purpose drawer" above to remove the misfed paper. q If paper is misfed on the left paper feed table: Raise the paper guide and remove the misfed paper. 4 Gently close the large capacity tray. Push back the paper tray all the way into the machine. 5 Gently close the duplex module. If the machine is not equipped with the duplex module, close the side cover similarly. After closing the duplex module, confirm that the misfeed message is cleared and that the normal display appears. 4-5