Sharp ER-A320 Programmer Manual - Page 24
Flash report, Overflow mark
UPC - 074927900194
View all Sharp ER-A320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
2. Flash report REPORT NAME KEY ENTRY NET3 DEPT DEPT/GROUP HOURLY CID CA/AT DPTn DPT# MDSE SBTL #/TM/SBTL @/FOR OP X/Z X Z MODE X1/Z1 X1 Z1 To read respective reports, it is necessary to follow the procedure below. TIME #/TM/SBTL TIME : 24 hour system (2 digits) To read respective reports, it is necessary to foIIow the procedupe below. XX Dept. code DEPT# To read respective reports, it is necessary to follow the procedure below. Group No. MDSE SBTL X2/Z2 X2 Z2 DATA FOR READING REMARK DEPT. CODE GROUP CODE TIME 3. Overflow mark If the amount in any totalizer other than GT to be printed on X or Z reports exceeds a programmed limit, the indication mark (overflow mark) is printed for the totalizer concerned. The overflow mark may be printed even it a totalizer does not reach the maximum amount. This occurs. for example, when the amount in the totalizer gets smaller than the maximum amount due to the entry of a negative amount after the overflowing of the totalizer. This means that when the totalizer overflows once. the overllow mark (for example, "555 ") is printed.