Sharp LC-60LE810UN Service Manual - Page 38

LC-40/46/52/60LE810UN (1st Edition) 3. Entering and exiting the adjustment process mode 1) Before entering the adjustment process mode, the AV position RESET in the video adjustment menu. 2) At the state TV is turned on, touch the power key for 5seconds. NOTE: Picture will disappear when you touch the power key, but keep touching the power key. 3) When the center icon LED blinks, release your finger from the power key. 4) Next, touch the power key with "VOL (-)" and "INPUT" keys at the same time. TV will turn on and the letter "" appears on the screen. 5) Next, touch the "VOL (-)" and "CH ( )" keys at the same time. 6) When the center icon LED turns on, release your finger form the keys. (The "VOL (-)" and "CH ( )" keys should be pressed and held until the display appears.) Multiple lines of blue characters appearing on the display indicate that the unit is now in the adjustment process mode. When you fail to enter the adjustment process mode (the display is the same as normal startup), retry the procedure. 7) To exit the adjustment process mode after the adjustment is done, unplug the AC cord from the outlet to make a forced shutdown. (When the power was turned off with the remote controller, once unplug the AC cord and plug it again. In this case, wait 10 seconds or so before plugging.) CAUTION: Use due care in handling the information described here lest your users should know how to enter the adjustment process mode. If the settings are tampered in this mode, unrecoverable system damage may result. 4. Remote controller key operation and description of display in adjustment process mode 1) Key operation Remote controller key CH ( / ) VOL (+/-) Cursor (UP/DOWN) Cursor (LEFT/RIGHT) INPUT ENTER Main unit key CH ( / ) VOL (+/-) Function Moving an item (line) by one (UP/DOWN) Changing a selected item setting (+1/ -1) Turing a page (PREVIOUS/NEXT) Changing a selected line setting (+10/ -10) Input switching (toggle switching) Executing a function *Input mode is switched automatically when relevant adjustment is started so far as the necessary input signal is available. 2) Description of display (1) Current page/ Total pages (2) Current selected input (3) Current color system (4) Destination (5) LCD Panel size/Speaker type 1/24 INPUT5 AUTO MAIN Version 1.09 (U 2009/07/07 1A) BOOT Version Monitor/Monitor BOOT Version LCD Con Version HLNI 100 1.02/1.00 0900626000T0001 LED TCON Version EQ DATA CHECKSUM 16 ROM TEMPERATURE 7B LAMP ERROR 0 USA MONITOR ERR CAUSE 0 NORMAL STANDBY CAUSE ERROR STANDBY CAUSE 0 1) 0 0H 0M 4) 0 0H 0M 2) 0 0H 0M 5) 0 0H 0M 40_UNDER 3) 0 0H 0M (6) Adjustment process menu header (7) Parameters 5 - 4