Sharp MX-M5050 Troubleshooting Guide - Page 8

General Problems ? Problem PAPER DOES NOT FEED FROM THE PAPER TRAY I DON'T KNOW HOW TO CHANGE THE PAPER SIZE THE OUTPUT IS NOTICEABLY CURLED AND UNEVEN THE IMAGE IS SKEWED ON THE PAPER LINES APPEAR IN THE SCANNED IMAGE SMUDGES APPEAR ON PRINTED OUTPUT WHEN PRINTING ON THICK PAPER, THE PRINT RESULT IS DIRTY FROM THE 2ND PAGE ON I DON'T KNOW HOW TO CHANGE THE OUTPUT TRAY PART OF THE IMAGE IS CUT OFF PRINTING TAKES PLACE ON THE WRONG SIDE OF THE PAPER A COVER OR INSERT IS NOT PRINTED ON THE SPECIFIED PAPER THE CONNECTED USB DEVICE CANNOT BE USED THE FINISHER/SADDLE FINISHER DOES NOT OPERATE STAPLING DOES NOT TAKE PLACE (INCLUDING SADDLE STITCH) PUNCHING DOES NOT TAKE PLACE Check Is the paper loaded correctly into the paper tray? Has the tray been prohibited in some modes (copy, print, fax, image send, document filing)? Set the paper size used in each tray in the tray settings. Page 15 15 15 Remove the paper, turn it over, and reload it. Using a different paper 16 type may solve the problem. Is too much paper loaded into the bypass tray? 16 Are the bypass tray guides adjusted to the width of the paper? 16 Are the original guides adjusted to the width of the paper? 16 Are you scanning originals of mixed width? (In a reversing single pass 16 feeder (RSPF)) Are the scanning areas of the document glass or automatic document 17 feeder dirty? Is the bypass feed roller dirty? 17 Did you clean the main charger of the photoconductive drum? 17 Are you using paper that is not within the specifications? 17 Are you printing on pre-punched paper? 17 Does a message appear indicating the need for maintenance? 17 Remove the paper, turn it over, and reload it. Using a different paper 17 type may solve the problem. Has the paper type been set correctly? 18 Did you change the output tray? 18 Has the correct paper size been set? 18 Was the original placed in the correct position? 18 Is the paper loaded with the print side facing in the correct direction? 19 Has the paper type been set correctly? 19 Is the USB device compatible with the machine? 19 Is the connected USB device recognized correctly? 19 Is the format of the USB memory device FAT32? 19 Are you using a USB memory device with a capacity of more than 32 19 GB? Does a message appear indicating that you need to remove paper from 20 the stapler compiler? Have functions been disabled by the administrator? 20 Does a message appear instructing you to check the staple unit? 20 Does a message appear instructing you to add staples? 20 Is a different width of paper mixed in? 20 Are there more sheets than can be stapled at once? 20 Is a paper size that cannot be stapled included in the print job? 20 Is the paper type setting of the tray selected in the printer driver set to a 20 paper type that cannot be stapled? Does a message appear instructing you to check the punch module? 21 Is a different size of paper mixed in? 21 Is a paper size that cannot be punched included in the print job? 21 Is the tray selected in the printer driver set to a paper type that cannot 21 be punched? 8