Sharp OZ-707 Operation Manual - Page 42
ecuting an Expression
![]() |
UPC - 074000012141
View all Sharp OZ-707 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Example: Correct the No.1 expression title "AREA" to "AREA 1". (Select "2. CORRECT & DELETE" in the AER menu.) Recall the title "AREA" by pressing the II AER II (title) key. Now the correction is complete and the AER menu is displayed. Deleting expressions Carry out the following procedure to delete an expression already stored. (1) Select "2. CORRECT & DELETE" in the AER menu and recall the expression to be deleted with thell AER II(title) key. (2) Press the I DELI key. "01 :AER data clear OK? (YIN)" will be displayed to confirm the deletion. "01" is the expression title number of the expression to be deleted. (3) Press the CYJ key to delete the expression or press the o=J key not to delete it. (For now, press the ~ key. The expression stored in "01" will be used in future examples.) Note: When an expression is deleted, the deleted storage area is filled with the expression following the deleted expression, so some expression title numbers may change. 72 Executing an Expression (1 ) Select "1. EXECUTE" in the AER menu and press thell AER II (title) key to recall the title and expression. (2) When the expression to be executed is recalled, press the I ENTER I key. (3) The entry prompt for the parameter(s) specified in F ( ) are displayed sequentially. Press the I ENTER I key after each numerical data entry. • If the I ENTER I key is pressed without numerical data entry, the most recently entered value will be used. (4) After parameter entry is completed, the calculated result will be displayed. To quit execution, press thell PLAY BACK II key when the calculated result is being displayed. Example: Perform calculations using the stored expression "AREA1". Set the RUN mode, and set the angular unit to degrees. Set the AER mode and select "1. EXECUTE" in the AER menu. Recall the title "AREA1" which expression is to be executed by pressing II AER II (title) key. IENTER I Enter the value for angle A. 30 IENTER I Enter the values for sides Band C. 100 I ENTER I 20 I ENTER I A=30 E,·--~·~ A=30 B=100 C=20 50€:1 73
![](/manual_guide/products/sharp-oz707-operation-manual-7aa0508/42.png)