Sharp PG-A10X Operation Manual - Page 62
Removing and Installing, the Lamp Unit - bqc 1
UPC - 074000358843
View all Sharp PG-A10X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Regarding the Lamp Removing and Installing the Lamp Unit Info • Be sure to remove the lamp unit using the handle. Be sure not to touch the glass surface of the lamp unit or the inside of the projector. • To avoid injury to yourself and damage to the lamp, be sure to carefully follow the steps below. • Do not loosen other screws except for the filter/lamp unit cover and lamp unit. • Please refer to the installation manual included with the lamp unit. 1 Press on the projector to turn off the power. • Wait until the cooling fan stops. Warning! • Do not remove the lamp unit from the projector right after use. The lamp will be very hot and may cause burn or injury. 2 Disconnect the power cord. • Unplug the power cord from the AC socket. • Leave the lamp until it has fully cooled down (about 1 hour). 3 Change the air filter. • Change the air filter whenever you install the lamp unit (see pages 53 and 54). 4 Remove the filter/lamp unit cover. • Turn the projector over. Loosen the user service screw (1) that secures the filter/lamp unit cover. Pressing the tab (2), remove the filter/lamp unit cover (3). 58 A10X_A10S#E_Print#p51_62.p65 58 Lamp unit BQC-PGA10X//1 Power OFF button AC socket 1 3 User service screw 2 Tab 03.2.4, 2:07 PM