Sharp PG-C20XU PG-C20XU Operation Manual - Page 15

Setup & Connections Connecting the Projector Connecting a video source (DTV decoder or DVD player) using the 15-pin input 1 Connect one end of the HD-15/RCA cable or the HD15-RGB cable to the COMPUTER INPUT 1 port on the projector. 2 Connect the other end to the corresponding terminals on the video source. 3 To use the built-in audio system, connect one end of the audio cable to AUDIO INPUT 1 terminal on the projector. Connect the other end to the audio output terminals on the video source. • The projector can only accept 480P DTV signals through COMPUTER INPUT 1 terminal. Therefore, set your DTV to RGB monitor output. • The image quality may become lower depending on DTV signal compatibility. Projector RS-232C INPUT 1 AUDIO COMPUTER HD-15/RCA cable (sold separately) 2 To video output terminals OUTPUT (INPUT 1) AUDIO CHOMDPU-TE1R5-RGB cable (sold separately) 2 To video output terminals Audio cable (sold separately) 3 To audio output terminals DTV decoder or DVD player Connecting an amplifier and other audio components 1 Connect one end of the audio cable to the AUDIO OUTPUT terminal for INPUT 1 on the projector. 2 Connect the other end to the corresponding terminals on the audio components. CAUTION • Always turn off the projector while connecting to audio components, in order to protect both the projector and the components being connected. Projector INPUT 1 O COMPUTER OUTPUT (INPUT 1) AUDIO COMPUTER • By using external audio components, the volume can be amplified for better sound. • The AUDIO OUTPUT terminal for INPUT 1 allows you to output audio to audio components from the AUDIO INPUT 1 terminal connected to audiovisual equipment. Audio cable (sold separately) To audio input terminals Amplifier E-14