Sharp PG-C20XU PG-C20XU Operation Manual - Page 18

Operation Basic Operations 3 4 3 Slide the ZOOM knob. The image can be adjusted to the desired size within the zoom range. 4 Rotate the FOCUS ring until the image on the screen becomes clear. Projector ON/OFF POWER LAMP TEMP. KEYSTONE INPUT AUTO SYNC BACK ENTER MENU EXAMPLE 5 INPUT 1 (RGB) Mode d INPUT 3 (VIDEO) Mode 6 7 Remote control 8 7 5 6 INPUT 1 (COMPONENT) Mode g f INPUT2 (S-VIDEO) Mode s 5 Press INPUT to select the desired input mode. Press INPUT again to change the mode. • When the selected input signal is being received, "Adjusting The Image" will be displayed. • When no signal is being received, "NO SIGNAL" will be displayed. When a signal that the projector is not preset to receive is being received, "NOT REG." will be displayed. 6 Press VOLUME on the remote control to adjust the volume. 7 Press AV MUTE on the remote control to temporarily turn off the picture and the sound. Press AV MUTE again to turn the picture and the sound back on. 8 Press ON/OFF on the projector or POWER on the remote control for over one second. Press ON/OFF or POWER again while the message is displayed. • If you accidentally pressed ON/OFF or POWER and do not want to turn off the power, wait until the power off screen disappears. • When ON/OFF or POWER is pressed twice, the POWER indicator will light up red and the cooling fan will run for about 90 seconds. The projector will then enter standby mode. • Wait until the cooling fan stops before disconnecting the power cord. • The power can be turned on again by pressing ON/OFF or POWER. When the power is turned on, the POWER indicator and the LAMP REPLACEMENT indicator light green. • The POWER indicator flashes if the right side filter cover is not securely installed. 8 E-17