Sharp PG-C355W Owners Manual for XG-C455W - Page 54

Helpful Functions Set during Installation ("PRJ-ADJ" menu) 8 Selecting the Transmission Speed (RS-232C) Make sure that both the projector and computer are set for the same baud rate. Selectable items 9600 bps 38400 bps 115200 bps Description Transmission speed is slow. Transmission speed is rapid. Note • Refer to the "SETUP MANUAL" contained on the supplied CD-ROM for RS-232C Specifications and Command Settings. • Refer to the computer's operation manual for instructions for setting the computer's baud rate. 9 Fan Mode Setting This function changes the fan rotation speed. Selectable items Description Normal Suitable for normal environments. High Select this when using the projector at altitudes of approximately 1,500 meters (4,900 feet) or more. When "Fan Mode" is set to "High", the fan rotation speeds up, and the fan noise becomes louder. 0 System Lock Function This function prevents unauthorized use of the projector. Once this function is activated, users must enter the correct keycode each time the projector is turned on. We suggest you record the keycode in a safe place where only authorized users have access. Info • If you lose or forget your keycode, contact your nearest Sharp Authorized Projector Dealer or Service Center (see page 68). Even if the product warranty is valid, the keycode reset will incur a charge. -52 Menu operation Page 43 Setting/Changing the keycode 1 Select "System Lock", then press ENTER or |. 2 Select "Next", then press ENTER. • The screen for entering the keycode appears. 3 Press the 4 buttons on the remote control or on the projector to enter the preset keycode in "Old Code". • When setting the keycode for the first time, press " on the projector for four times. Setting the System Lock PRJ-ADJ Old Code New Code Reconfirm Note • If you input a wrong keycode, the cursor returns to the first point of the "Old Code". • The preset keycode is 4 " buttons on the projector. When you press the " button four times, the keycord input screen disappears. 4 Press the 4 buttons on the remote control or on the projector to enter the new keycode in "New Code". Note • You cannot use the following buttons for keycode: STANDBY/ON, ON, STANDBY, ENTER, L-CLICK, R-CLICK/RETURN, MENU, ECO+QUIET and BREAK TIMER • System lock function recognizes each button on the remote control or on the projector as an individual button, even if they share the same button name. If you used the buttons on the projector in setting your keycode, the keycode cannot be canceled with the remote control. Setting the System Lock PRJ-ADJ Old Code New Code Reconfirm **** ---- ----