Sharp PG-C355W Owners Manual for XG-C455W - Page 56

Setting up the Projector Network Environment ("Network" menu) Pict. SIG 1 Password 2 DHCP Client 3 TCP/IP SCR PRJ Network Disable Off MAC Address XX:XX:XX:XX:XX:XX 4 Projector XX-XXXX SEL./ADJ. RETURN ENTER END 1 Setting a Password If you do not want others to change the setting for the "Network" menu, set a password. Setting a Password 1 Select "Password", then press |. • The screen for entering the password appears. Setting the Password Network Old Password New Password Reconfirm 2 Press ' or " to set the first digit in "New Password", then press |. 3 Enter the remaining 3 digits, then press ENTER. • To return to the previous digit, press \. 4 Enter the same password in "Reconfirm", then press ENTER. • The status for "Password" changes to "Enable". Note • Once after the password is set, you must enter the password to change the "Network" menu settings. Menu operation Page 43 Changing the Password 1 Select "Password", then press |. • The screen for entering the password appears. 2 Enter the password in "Old Password" using ', ", | and \, then press ENTER. 3 Enter the password in "New Password" using ', ", | and \, then press ENTER. 4 Enter the same password again in "Reconfirm" using ', ", | and \, then press ENTER. Note • If you do not need the password protection for the "Network" menu settings anymore, press ENTER without entering new password in steps 3 and 4. • To cancel the password settings, press RETURN. If you forget the password If you forget the password, perform the following procedure to delete it, then set a new password. On the projector, press Note • If ENTER is held down for more than 5 seconds, the operation buttons on the projector will be locked. (See page 53.) • You cannot use the buttons on the remote control to delete the password. -54