Sharp R930AK Service Manual - Page 35

33 6 5 4 3 2 1 H H CN-F 1 BLK 2 RED 3 WHT AH SENSOR CONTROL PANEL CN-G IC-1 3 1 CN-F COM. RY3 N.O. COM. RY2 N.O. COM. RY1 N.O. RY5 RY4 1 3 5 7 9 CN-A RY6 CN-E 6 PNK 5 PNK 4 RED CN-E 3 RED 6 2 GRN 5 1 ORG 4 3 2 RY3 (COM.) BRN 1 RY3 (N.O.) RED BRN RY2 (COM.) BRN ORG RY2 (N.O.) ORG RY1 (COM.) BLK RY1 (N.O.) BRN RED CN-A T1 1 ORG 2 3 BRN 4 5 PPL 6 7 8 9 WHT G G F F E E D D DOOR SENSING SWITCH N.O. ORG COM GRN BLK MONITOR FUSE & FUSE HOLDER RED MONITOR SWITCH N.C. GRY WHT ORG COM OVEN LAMP & SOCKET BLK GRN GRN GRY WHT NOTE: Hot (YLW & PNK) wire must be connected to the terminal with blue mark on the oven light socket. RED PNK BLUE MARK N.O. DAMPER PNK SWITCH PNK COM HEATING ELEMENT R GG E RR D YY MAGNETRON TEMPERATURE FUSE RED HIGH VOLTAGE COMPONENTS RED MAGNETRON GRY BLK RED ORG HIGH VOLTAGE CAPACITOR POWER TRANSFORMER WG HR TY NOTE: Hot (ORG) wire must be connected to the power transformer terminal nearest to the transformer mounting screw. WHT WHT DAMPER MOTOR ORG CONVECTION MOTOR GRY BRN WW P HH P TT L COOLING FAN MOTOR OVEN THERMAL CUT-OUT RED BLK NOTE: The grounding conductor of the power supply cord has been grounded by power supply cord fixing screw. The screw must be kept allways tight. N.O. WHT COM SECONDARY INTERLOCK SWITCH WHT GRY GRY GRY PNK TURNTABLE MOTOR THERMISTOR RED 2 RED RED 1 RED N.O. WHT PNK H N GRN PNK RED COM OUTER CASE SWITCH (Oven side) N.O. NOTE: The neutral (WHT) wire must be connected to the terminal with "N" mark on the power supply cord. WHT GRY COM POWER SUPPLY CORD 120V 60Hz OUTER CASE SWITCH (Cabinet side) Figure S-1. Pictorial Diagram C C B B A A 6 5 4 3 2 1 R-930AK R-930AW