Sharp TM200 Service Manual - Page 78
Buffer Gated switching signal for I/O
View all Sharp TM200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
CONFIDENTIAL Pin Terminal Input/ No. name Output Description of terminal 119 DB14 Input/ Data bus Output 120 DB15 Input/ Data bus Output 121 WAIT_B Output External wait signal ("Low" is active) 122 SUBFLMIN Input Driver FLM signal input for External display 123 SUBCKS Output Clock switching signal for External display 124 DA1 Input/ Address input for chip select decode Output 125 BSPIXEL1 Input/ External Bit Stream data bus Output 126 BSPIXEL4 Input/ External Bit Stream data bus Output 127 GND - Logic ground 128 BSPIXEL5 Input/ External Bit Stream data bus Output 129 SE_CK/PORT1 Output Control clock for 4-wire serial IF (default) General-purpose PORT output 130 SE_LD2/PORT5 Output Load signal 2 for 4-wire serial IF General-purpose PORT output (default) 131 BUFOFF_B Input Buffer Gated switching signal for I/O through current prevention (High when Host_IF signal is activated) 132 VDDIO - IO Power supply 3.0 V (2.7 V~ 3.3 V) 133 134* DUMMY2 SE_LD3/PORT6 Output Dummy 2 Load signal 3 for 4-wire serial IF General-purpose PORT output (default) (Not used) 135 VDDIO - IO Power supply 3.0 V (2.7 V~ 3.3 V) 136 SUBLPIN Input Driver LP input External display 137 BSPIXEL2 Input/ External Bit Stream data bus Output 138 BSPIXEL3 Input/ External Bit Stream data bus Output 139 VDDCORE - CORE Power supply 1.8 V (1.6 V~ 2.0 V) 140 SE_DI/PORT7 Input/ 4-wire serial input (default) GeneralOutput purpose PORT output 141 SE_LD1/PORT2 Output Load signal 1 for 4-wire serial IF (default) General-purpose PORT output 142 GND - Logic ground 143 VDDCORE - CORE Power supply 1.8 V (1.6 V~ 2.0 V) 144 DUMMY1 - Dummy 1Dummy 4 In this unit, the terminal with asteriskmark (*) is (open) terminal which is not connected to the outside. TM200 OTHERS 6 - 13