Sharp UP-3500 UP-3500 Operation Manual - Page 263

11 Data Saving or Loading (SD Card) The POS terminal data can be saved to the SD memory card, and the programming data can be loaded from the SD memory card. To use the SD memory card function, select the "SD CARD" mode in the mode selection window and perform the following operations. Inserting and Removing an SD Memory Card The SD card slot is located on the left side of your POS terminal and has a side cover. Inserting an SD memory card Insert an SD memory card into the SD card slot with the printed SD logo facing upwards. Push the card in steady with a finger until it clicks and release it slowly. Removing the SD memory card Push the card in gently with a finger and release it. The card will Come out. • This model supports SD cards only. Use of any other types of SD cards such as mini SD, micro SD, etc. with an adapter is not supported. • When inserting or removing the SD memory card, be sure to release it slowly. Otherwise, the card may pop out and injure your finger. • Never touch or remove the SD memory card while it is accessed, otherwise the data stored in it may be damaged. • Formatting the SD memory card erases all the data in it. I SD memory card formatting When the SD memory card is not formatted yet, take the formatting operation. (1) Select the "FORMATTING" menu in the "SD CARD" mode, the confirmation window is displayed. (2) To perform the format operation, touch the [OK] key. (2)' To cancel the operation, touch the [CANCEL] key. I Folder code programming The programmed code is used the file folder structure. Up to 8 digits code can be programmed. (1) Select the "FOLDER CONTROL" menu in the "SD CARD" mode, the folder control menu window is displayed. (2) Select the "FOLDER CODE" menu and enter the folder codes. (2)' To cancel the operation, touch the [EXIT] key. 261