Sharp UP-700 Programming Guide - Page 16
Device Config] - [14 Cat#1], 01 Device Config] - [15 Cat#2], 01 Device Config] - [16 Reserved],
![]() |
View all Sharp UP-700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
[01 DEVICE CONFIG] - [14 CAT#1] DISPLAY: Setting screen [CAT#1] DISPLAY TERMINAL# CONTENTS Terminal No. CHANNEL# Channel No. SELECT ITEM 000-254 0-7 MRS 000 0 NOTE 000 :Self terminal No. This means local device. 1-254 : Except self terminal No. 0 : No RS232 channel is assigned. 1-7 : RS232 channel is assigned. [01 DEVICE CONFIG] - [15 CAT#2] RESERVED [01 DEVICE CONFIG] - [16 RESERVED] [01 DEVICE CONFIG] - [17 BCR(SCANNER)] DISPLAY: Setting screen [BCR (SCANNER)] DISPLAY CHANNEL# BAUD RATE CONTENTS Channel No. Transmission speed DATA BITS PARITY Data bit Parity bit STOP BIT Stop bit SELECT ITEM 0-7 4800 bps 9600 bps 19200 bps 7 Bits 8 Bits ODD EVEN NON 1 Bits 2 Bit MRS 0 4800 bps NOTE 0: No RS232 channel is assigned. 1-7: RS232 channel is assigned. 7 Bits ODD 1 Bit ER-A6HS1 setting : "BAUD RATE = 4800 bps" , "DATA BITS = 7Bits", "PARITY = ODD", "STOP BIT = 1Bit" NOTE: 1. Set the channel No. so that it does not conflict with other devices that are to be connected. If this occurs, the unit will not operate properly. 2. Do not use channel No. 2 for the ER-A6HS1. Use other channel Nos. 3. If you want to change the channel No. of the BCR (Scanner), set a channel No. that is other than 0 and does not conflict with other devices.
![](/manual_guide/products/sharp-up700-programming-guide-7150148/16.png)