Sharp VN-EZ1U VNEZ1U Operation Manual - Page 82

References Symptom Cannot play back Possible cause • The lens body • mark not aligned with PLAY • . Suggestion • Rotate the lens body to align with PLAY • . • The Mode (MOVIE/STILL) select switch not • Securely set the Mode select switch (page 22). set securely. • Dead batteries. • Replace the batteries with new ones or fully charged rechargeable batteries (page 14). • The SmartMedia card not loaded properly, • Correctly load the SmartMedia card (page 17). or no card loaded. Bad picture quality 4a:1. a. • Occurs when recorded in the LP (Movie Recording) or NORMAL (Still Recording) mode which tends to lower quality to record longer movie or larger number of still images. • Change the resolution setting as you desired (see pages 45 and 46). No sounds during the • The volume set in too low. Movie playback mode. Cannot delete images. • The write-protect seal attached to the SmartMedia card. • The images delete-protected. Cannot format the SmartMedia card. • The write-protect seal attached to the SmartMedia card. • Press A on the operation button to turn the volume XI up. CD CD • Remove the write-protect seal (page 5). CD CD CcnD • Unprotect the desired images (page 38). • Remove the write-protect seal (page 5). Note: • The Digital Recorder is equipped with a microprocessor. Its performance could be adversely affected by external electrical noise or interference. If this should happen, turn off the power and disconnect the Digital Recorder from any power sources. Then reconnect the power sources to resume operation. 72