Sharp XV-Z9000U XVZ9000U Operation Manual - Page 17

Setup & Connections Power ON/OFF POWER buttons TEMP. LAMP POWER Press POWER ON. • The flashing blue LAMP REPLACEMENT indicator shows that the lamp is warming up. Wait until the indicator stops flashing before operating the projector. • If the power is turned off and then immediately turned on again, it may take a short while before the lamp turns on. • After the projector is unpacked and turned on for the first time, a slight odor may be emitted from the exhaust ventilative hole. This odor will soon disappear with use. When the power is on, the LAMP REPLACEMENT indicator lights, indicating the status of the lamp. Blue: Lamp is ready. Flashing blue: Warming up. Red: Change the lamp. Press POWER OFF. Press POWER OFF again while the message is displayed. • If you accidentally pressed POWER OFF and do not want to turn off the power, wait until the message disappears. • When POWER OFF is pressed twice, the POWER indicator will light up red and the cooling fan will run for about 90 seconds. The projector will then enter standby mode. • Wait until the cooling fan stops running before disconnecting the power cord. • The power can be turned on again by pressing POWER ON. When the power is turned on, the POWER indicator and the LAMP REPLACEMENT indicators light blue. Zooming and Focusing The picture can be zoomed in or out, and focused by the Zoom knob and the Focus ring. 1 Slide the Zoom knob. The image can be adjusted to the desired size within the zoom range. 2 Rotate the Focus ring until the image on the 1 screen becomes clear. 2 E-17