Snapper 150Z Operater's Manual - Page 17
Pushing The Rider By Hand, Starting The Engine, Mowing
View all Snapper 150Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Operation Starting The Engine Pushing The Rider By Hand 1. While sitting in the seat, make sure the mower blade switch is OFF, the ground speed control levers are locked in START/PARK positions, and the parking brake is engaged. 2. Move the engine speed control/choke to the choke position for starting a cold engine. A warm engine may not require choking. 3. Insert the key into the ignition switch and turn it to START to crank the engine. NOTE: Do not disengage the transmissions if parked on a slope. 1. Turn the mower blades OFF, push the ground speed control levers out to their START/PARK positions, engage the parking brake, turn the ignition switch OFF, remove the key, and wait for all moving parts to stop. 2. Locate the transmission release levers (C, Figure 3) 4. After the engine starts, release the key. It will return at the rear of the unit. to the RUN position. 3. Pull both levers back and down to release the 5. Move the engine speed control/choke to the FAST transmissions (position B, Figure 3). position to increase engine speed and SLOW position to decrease engine speed. Always operate with engine speed set to FAST. 6. Warm the engine by running it for at least a minute before turning on the mower blades, or driving the 4. Pull the ground speed control levers in to their DRIVE positions, and disengage the parking brake. The rider can now be pushed by hand. 5. After moving the rider, set the ground speed control unit. ALWAYS operate the unit with the engine speed control set to FAST when mowing or driving. r n NEVER engage the mower blades with the engine speed set to SLOW. fo tio Mowing t 1. Start the engine (see STARTING THE ENGINE). c 2. Set the mower cutting height to the desired setting o u using the mower cutting height switch. N d 3. Set the engine speed control to FAST. 4. Turn the mower blades ON (pull switch up). o 5. Disengage the parking brake. r 6. Move the ground speed control levers in from START/ p PARK positions to drive positions (levers in across the operator's lap). e 7. Begin mowing. See DRIVING PRACTICE. R 8. When finished, turn the mower blades OFF (push levers to START/PARK, engage the parking brake, and push both transmission release levers forward to re-engage the transmissions (position A, Figure 3). NOTICE do not tow rider Towing the unit will cause transmission damage. Do not use another vehicle to push or pull this unit. Do not use this unit to push or pull another vehicle or object. A switch down). 9. Stop the rider and engine (see STOPPING THE RIDER AND ENGINE). B C Figure 3. Transmission Release Levers 17