Snapper 150Z Operater's Manual - Page 25
Clean the Battery and Cables
View all Snapper 150Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Maintenance Clean the Battery and Cables WARNING Be careful when handling the battery. Avoid spilling electrolyte. Keep flames and sparks away from the battery. When removing or installing battery cables, disconnect the negative cable FIRST and reconnect it LAST. If not done in this order, the positive terminal can be shorted to the frame by a tool. Always wear safety glasses and gloves when handling batteries. B A 1. Disconnect the cables from the battery, negative cable first (B, Figure 24). Figure 24. Engine Compartment 2. Remove the rubber strap securing the battery, and remove the battery. 3. Clean the battery and battery compartment with a solution of baking soda and water. r n 4. Clean the battery terminals and cable ends with a fo tio wire brush until shiny. 5. Reinstall the battery and secure with the rubber strap. t c 6. Reattach the battery cables: first attach the positive cable (see A, Figure 32), then attach the negative o u cable (B). N d 7. Coat the cable ends and battery terminals with petroleum jelly or non-conducting grease. o Note: On models with 33" decks, the battery is mounted Repr on the right side of the engine compartment. 25