Sony Ericsson W800i User Guide - Page 35

Antenna, Efficient use, Radio frequency RF exposure and, Specific Absorption Rate SAR is the unit - mobile phone

Page 35 highlights

Important information • Do not use your product when in, or around aircraft, or areas posted "turn off two-way radio". • Do not use your product in an area where a potentially explosive atmosphere exists. • Do not place your product or install wireless equipment in the area above your car's air bag. • Do not attempt to disassemble your product. Only Sony Ericsson authorised personnel should perform service. Antenna Only use an antenna that has been specifically designed by Sony Ericsson for your mobile phone. Use of unauthorised or modified antennas could damage your mobile phone and may violate regulations, causing loss of performance and SAR levels above the recommended limits (see below). Efficient use Hold your mobile phone as you would any other phone. Do not cover the top of the phone when in use, as this affects call quality and may cause the phone to operate at a higher power level than needed, thus shortening talk and standby times. Radio frequency (RF) exposure and SAR Your mobile phone is a low-power radio transmitter and receiver. When it is turned on, it emits low levels of radio frequency energy (also known as radio waves or radio frequency fields). Governments around the world have adopted comprehensive international safety guidelines, developed by scientific organizations, e.g. ICNIRP (International Commission on Non-Ionizing Radiation Protection) and IEEE (The Institute of Electrical and Electronics Engineers Inc.) through periodic and thorough evaluation of scientific studies. These guidelines establish permitted levels of radio wave exposure for the general population. The levels include a safety margin designed to assure the safety of all persons, regardless of age and health, and to account for any variations in measurements. Specific Absorption Rate (SAR) is the unit of measurement for the amount of radio frequency energy absorbed by the body when using a mobile phone. The SAR value is determined at the highest certified power level in laboratory conditions, but the actual SAR level of the mobile phone while operating can be well below this value. This is because the mobile phone is designed to use the minimum power required to reach the network. Variations in SAR below the radio frequency exposure guidelines do not mean that there This is the Internet version of the user's guide. © Print only for private use. 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44

This is the Internet version of the user's guide. © Print only for private use.
Important information
35
Do not use your product when in, or
around aircraft, or areas posted “turn off
two-way radio”.
Do not use your product in an
area where a potentially
explosive atmosphere exists.
Do not place your product or
install wireless equipment in the
area above your car's air bag.
Do not attempt to
disassemble your product. Only
Sony Ericsson authorised
personnel should perform
service.
Antenna
Only use an antenna that has been
specifically designed by Sony Ericsson for
your mobile phone. Use of unauthorised or
modified antennas could damage your
mobile phone and may violate regulations,
causing loss of performance and SAR levels
above the recommended limits (see below).
Efficient use
Hold your mobile phone as you would any
other phone. Do not cover the top of the
phone when in use, as this affects call
quality and may cause the phone to operate
at a higher power level than needed, thus
shortening talk and standby times.
Radio frequency (RF) exposure and
SAR
Your mobile phone is a low-power radio
transmitter and receiver. When it is turned
on, it emits low levels of radio frequency
energy (also known as radio waves or radio
frequency fields).
Governments around the world have
adopted comprehensive international safety
guidelines, developed by scientific
organizations, e.g. ICNIRP (International
Commission on Non-Ionizing Radiation
Protection) and IEEE (The Institute of
Electrical and Electronics Engineers Inc.)
through periodic and thorough evaluation of
scientific studies. These guidelines establish
permitted levels of radio wave exposure for
the general population. The levels include a
safety margin designed to assure the safety
of all persons, regardless of age and health,
and to account for any variations in
measurements.
Specific Absorption Rate (SAR) is the unit
of measurement for the amount of radio
frequency energy absorbed by the body
when using a mobile phone. The SAR value
is determined at the highest certified power
level in laboratory conditions, but the actual
SAR level of the mobile phone while
operating can be well below this value.
This is because the mobile phone is
designed to use the minimum power
required to reach the network.
Variations in SAR below the radio frequency
exposure guidelines do not mean that there