Sony 400K Operating Instructions - Page 111

The message "SAVE OK? YES b NO" appears. P00 USER SAVE ESC SAVE OK? YES NO DISPLAY MODE : ALL 001.NEW FILE 002.NEW FILE 003.NEW FILE 004.NEW FILE 005.NEW FILE When a file number is shown as NEW FILE, this means that the file is empty. When data is stored in a file number, the file name appears. 5 To carry out the save, turn the MENU knob to move b to YES and press the MENU knob. To cancel, press the MENU knob leaving b pointing to NO. The access indicator lights. When the saving is completed, the message "COMPLETE" appears and the access indicator goes off. If no "Memory Stick" has been inserted, the message "NO MEMORY STICK" will appear. Insert a "Memory Stick". If you select a file number where data has already been saved The message "OVERWRITE OK? YES b NO" appears. • To stop overwriting, press the MENU knob leaving b pointing to NO. • To overwrite, turn the MENU knob to move b to YES and press the MENU knob. You can select the information displayed on each USER SAVE or USER LOAD page. For details, see "To select the display contents" on page 111. About the USER menu settings to be saved in the "Memory Stick" Settings for items on all pages of the USER menu are saved in the "Memory Stick" as a user file. If data cannot be saved If one of the following error messages appears during or after the save operation, then the data was not saved. Error message Cause Action NO MEMORY STICK (flashing) No "Memory Stick" Insert or reinsert is inserted. the "Memory Stick". MEMORY STICK LOCKED The LOCK switch on the "Memory Stick" is set to the write protect position. Set the LOCK switch to the write enable position. MEMORY STICK ERROR (flashing) Circuit or "Memory Stick" fault. Check the circuitry, or replace the "Memory Stick". To set the file ID Before data is saved to a "Memory Stick", it is useful to set a file ID for the "Memory Stick" to identify it. When data is saved to a "Memory Stick", the file ID is saved to the "Memory Stick" together with the data. Note Set the file ID before saving data in the "Memory Stick". Otherwise, the file ID is not saved with the other data. 1 Display the USER FILE page of the FILE menu. For details on menu operations, see "Basic menu operations" on page 93. 2 Press the MENU knob. Then turn the MENU knob to move b to F. ID, and then press the MENU knob again. A character table appears. F01 USER FILE USER FILE LOAD : USER FILE SAVE : F.ID :?x TOP EXEC EXEC $%&'()*+,-./0123456789: ;?@ABCDEFGHIJKLMNOPQR STUVWXYZ[\]_ INS DEL RET ESC END 3 Follow steps 3 and 4 described in "Setting the shot ID" on page 101 to enter characters. 4 When you finish entering the file ID, turn the MENU knob to move x to END, then press the MENU knob. The entered file ID is now displayed. 13 USER FILE USER FILE LOAD : USER FILE SAVE : F.ID : ID-001 USER PRESET : TOP EXEC EXEC EXEC File ID that has been set appears. After setting the file ID, carry out the procedure from step 2 in "Saving USER menu data (user file) to the "Memory Stick"" on page 110. The set file ID is saved in the "Memory Stick" with the data. To select the display contents You can select the contents of the file to be displayed on the USER FILE SAVE page and USER FILE LOAD page Chapter 6 Saving and Loading the User Setting Data 111 Saving and Loading User Files