Sony 400K Operating Instructions - Page 57
Adjusting the audio level, Setting the time data, To manually adjust the levels of the audio - an hour
View all Sony 400K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
You can see the iris sensitivity trimmer when removing the gum cap on the front of the lens driving unit. Use a miniscrewdriver to turn the trimmer. If you turn it clockwise, the sensitivity increases, and if you turn it counterclockwise, the sensitivity decreases. It is recommended that you confirm the iris sensitivity after replacing the lens. For more information, refer to the operating instructions for the lens (or consult the lens maker). The input level value of the audio channel 1 is the value of the AUDIO LEVEL CH-1 control on the side multiplied by the value of the AUDIO LEVEL control on the front. The input level value of the audio channel 2 is the value of the AUDIO LEVEL CH-2 control. When the top bar (0 dB) turns on, the audio level is too high. There is no problem if the second bar from the top turns on. Adjusting the audio level Setting the AUDIO SELECT (CH-1/CH-2) switches to AUTO automatically adjusts the input levels of the audio signal to be recorded in audio channels 1 and 2. To manually adjust the levels of the audio inputs from the AUDIO IN CH-1/CH-2 connectors Proceed as follows to adjust the levels of the audio inputs from the AUDIO IN CH-1/CH-2 connectors, which are to be recorded in audio channels 1 and 2. These bars turn on. All bars turn on. Normal input level Excessive input level To adjust manually the level of audio channel 1 without using the AUDIO LEVEL control on the front of the camcorder Set F AUDIO VOL to DISABLE on the AUDIO page of the MAINTENANCE menu. The setting of the AUDIO LEVEL control on the front of the camcorder is disabled. Chapter 4 Recording and Playback Setting the time data 3 AUDIO LEVEL AUTO MANUAL AUDIO SELECT 3 2 1 Select the audio channel that you want to record in. For details, see "Selection of the recording audio input" on page 37. 2 Set the AUDIO SELECT (CH-1/CH-2) switch(es) corresponding to the audio channel(s) selected in step 1 to MANUAL. 3 With the AUDIO LEVEL control on the side of the camcorder and the AUDIO LEVEL control on the front of the camcorder, adjust so that the audio level meter shows up to -20 dB for a normal input volume. To set the time code The time code setting range is from 00:00:00:00 to 23:59:59:29 (DSR-400/450WS) or 23:59:59:24 (DSR400P/450WSP) (hours: minutes: seconds: frames). Note When the scan mode is 24P, see "Setting the CCD scan mode (DSR-450WS/450WSP only)" on page 107 (DSR450WS only). 2 1 5 PRESET REGEN CLOCK F-RUN SET R-RUN 3 4,6 1 Press the DISP SEL button of the LCD monitor to display the STATUS screen. 57 Recording