Sony CCD-TR40 Primary User Manual - Page 44

Trouble Check If you run into any problem using the camcorder, use the following table to troubleshoot the problem. Should the difficulty persist, disconnect the power source and contact your Sony dealer or local authorized Sony service facility. Camcorder Symptom Cause Corrective Actions Page The power is not on. The battery is not attached. Attach the battery. 7 The battery is dead. Use a charged battery. 6 The AC power adaptor is not connected to a wall outlet. Connect the AC power adaptor to a wall outlet. 22 The power goes off. s- 1 et While being operated in CAMERA mode, the camcorder has been in the Standby mode for more than 5 minutes. The battery is dead. Turn STANDBY down once and turn it up again. 13 Use a charged•battery. 6 The battery pack is quickly discharged. The ambient temperature is - 8 too low. The battery pack has not Charge the battery pack again. 6 been charged fully. The battery pack is Use another battery pack. completely dead, and cannot 9 be recharged. START/STOP does not The tape is stuck to the operate. drum. Eject the tape. 11 The tape has run out. Rewind the tape or use a new 20 one. The POWER switch is set to PLAYER. Set it to CAMERA. 13 The tab on the cassette is out (red). Use a new tape or slide the tab. 14 Operation The cassette cannot be removed from the holder. The battery is dead. Use a charged battery or the AC power adaptor. 6 22 No function except for Moisture condensation has Remove the cassette and leave cassette ejection works. occurred. the camcorder for at least an 33 hour. The tape does not move The POWER switch is set Set it to PLAYER. when a tape transport to CAMERA or OFF. 20 button is pressed. The tape has run out. Rewind the tape or use a new one. 20 The power zoom button WIDE ANGLE is working. does not work. This is not the malfunction. Slide the WIDE ANGLE switch in the 16 opposite direction of the arrow. I