Sony CCD-TR40 Primary User Manual - Page 7
Installing, Battery
View all Sony CCD-TR40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Important! Use the battery completely before re-charging! Before you recharge the battery, make sure the battery has been used up (discharged) completely. Repeated charging while some capacity remains causes a lowering of battery capacity. However, the original battery capacity can be recovered if you use the battery completely and charge it fully again. To use up the battery, remove the cassette and slide the POWER switch to CAMERA with the battery attached, and leave the camcorder until the .M3 indicator and the red lamp flash in the viewfinder. Removing the Battery Pack Slide the battery pack in the direction of the arrow (see drawing). Note on charging the battery pack • The POWER lamp will remain lit for a while even if the battery pack is removed and the power cord is unplugged after charging the battery pack. This is normal. • If the POWER lamp does not light, set the selector to the center position and disconnect the power cord. After about one minute, reconnect the power cord and set the selector to CHARGE again. • You cannot operate the camcorder using the AC power adaptor while charging the battery pack. Installing the Battery Pack (1) Lift up the viewfinder. (2) Align the right side of the battery pack with the white line on the camcorder, and slide the battery pack to the right. 2 7