Sony DIR-TC1 Instruction Manual - Page 11
Installing the IR Transmitter and the IR Receiver on a Wall, Installing the IR transmitter, on a wall
View all Sony DIR-TC1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Installing the IR Transmitter and the IR Receiver on a Wall You can hang the IR transmitter and IR receiver on a wall when: - there is an obstruction between the IR transmitter and the IR receiver. - people often pass between the IR transmitter and the IR receiver. When hanging both the IR transmitter and IR receiver, adjust the position of the IR transmitter after deciding the position of the IR receiver. Installing the IR transmitter on a wall 1 Rotate the stand of the IR transmitter. IR transmitter 3 Hang the IR transmitter by the hole on the bottom of the stand on the screw. Make sure that the IR transmitter does not move after installation. IR transmitter Stand Tip • You can store the cords in the troughs in the bottom of the stand. Stand Troughs Stand 2 Install 2 commercially available screws in the wall so as to protrude 4 mm (3/16 inch). Install the screws 30 mm (1 3/16 inches) apart. 30 mm (1 3/16 inches) Note • Use screws suitable for the material and strength of the wall. • Do not install the IR transmitter on a wall of low strength. • Sony is not liable for any damage or accident incurred by incorrect installation (i.e. low strength wall, etc.), incorrect use of this product, or natural disaster. • When connecting/disconnecting the cord, detach the IR transmitter from the wall first. 5 to 7 mm (7/32 to 9/32 inch) 4 mm (3/16 inch) continued 11GB